Wood & steel frame
Wrought iron
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Motor & Opener Cost in Hollywood?
Most gate motor and opener work in Hollywood runs $450 to $1,900 for a full automated operator install, while repairs to an existing motor typically land between $180 and $650 depending on the part and brand. A straight replacement of a failed swing or slide operator on a gate you already own usually falls in the $700 to $1,400 range. Carter Gate Repair works on LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule operators, so the number you get quoted reflects your actual gate, not a sales sheet.
Key Takeaways
- Repair of an existing operator: $180 to $650, most jobs same-week.
- Replace a failed motor on an existing gate: $700 to $1,400.
- New automated opener with controls and safety edges: $450 to $1,900.
- High-cycle commercial operators (DoorKing, FAAC) push toward the top of every range.
- We work on the gate you have. Brand-agnostic service means no forced replacement.
If your gate is stuck, binding, or the arm won’t respond to the remote, call (866) 665-5592 for a free estimate. We’ll tell you whether it’s a repair or a replacement before we touch a wrench.
Gate Motor & Opener Cost Breakdown (2026)
Hollywood prices track South Florida labor and parts costs. Salt air off the beach and the humidity near the Intracoastal push corrosion repair higher than inland markets, so expect the upper end of these ranges on barrier-island properties and older installs in the Lakes and downtown corridor. Here’s what the work typically runs in 2026.
| Service / Part | Typical Price Range | Notes |
|---|---|---|
| Diagnostic / service call | $75 – $150 | Often credited toward the repair |
| Control board replacement | $220 – $480 | Varies by brand and board |
| Motor or gearbox rebuild | $300 – $650 | Common on aging swing operators |
| Replacement opener (residential swing) | $700 – $1,200 | LiftMaster, Viking, Elite fit here |
| Replacement opener (residential slide) | $800 – $1,400 | Linear, Ghost Controls, Mighty Mule |
| High-cycle commercial operator | $1,200 – $1,900 | DoorKing, FAAC slide operators |
| New automated swing gate system | $1,400 – $3,200 | Operator, arms, controls, safety edges |
| Safety edge / photo-eye replacement | $180 – $320 | Required for code-compliant operation |
| Loop detector repair or replace | $200 – $400 | Common failure on driveway exits |
| Remote / keypad / receiver | $80 – $250 | Per device, brand-dependent |
| Battery backup module | $150 – $350 | Useful during storm-season outages |
What pushes a job toward the high end? High-cycle commercial hardware, second-story or gated-community access, concrete anchor work, and any operator that needs new low-voltage wiring run to the control box. What pulls it down? A clean swap where the gate itself is sound and the mounting is already correct. That last point is why we diagnose before we quote. Half the operators we look at in Hollywood don’t need replacing at all; the control board or a single failing arm is the problem. Call (866) 665-5592 and we’ll confirm it with you on site.
What Affects Gate Motor & Opener Pricing in Hollywood
Two gates with the same brand operator can quote $400 apart. Here’s what actually moves the number here in Hollywood.
- Salt air and humidity. Properties east of the Intracoastal, on Hollywood Beach and along the barrier island, see faster corrosion on arms, hinges, and control-box terminals. That means more prep work and more frequent component replacement than an inland gate in Pembroke Pines or Miramar, which is why we often recommend marine-grade hardware on beachside installs.
- Gate weight and type. A light residential single-swing gate takes a lighter-duty operator and less anchor work than a wide double-swing or a sliding gate with a concrete track. Heavier gates pull a stronger, more expensive operator and take longer to mount.
- Operator brand and cycle rating. A Mighty Mule or Ghost Controls diagonal-arm operator for a home driveway is a different price world than a DoorKing swing operator built for a condo association running hundreds of cycles a day. Matching the operator to actual traffic keeps you from overspending.
- Low-voltage wiring and access control. Electric gate repair at the control box – loop detectors, safety edges, keypads, phone access – takes a specialist’s time. If the wiring run needs repair or the access control has to be re-integrated, that adds to labor.
- Storm-related damage. After a hurricane or a heavy rainy season, we see a wave of water-ingress failures in control boxes and photo-eyes here. Hurricane-preparedness work on the gate wiring and water sealing is worth factoring in if your operator is exposed.
- Age of the existing system. A 15-year-old operator with parts that no longer exist may not be worth a rebuild. When repair costs cross roughly 60% of a replacement, we tell the customer that straight rather than patch it and send them a bill three months later.
If you’re not sure which of these applies to your gate, that’s what the estimate is for. We’ve seen the failure modes across nine brands, and we usually know what you’re dealing with in the first few minutes. Learn more about our Gate Motor & Opener in Hollywood service.
How to Save on Gate Motor & Opener
You don’t have to replace an operator to fix a bad gate, and you don’t have to pay dealer-inflated prices to get good hardware. Here’s where the savings actually live.
- Get a real diagnosis before you replace. A control board or a single failing arm is far cheaper than a whole new operator. We quote the fix, then tell you honestly if a replacement makes more financial sense. Free estimates start at (866) 665-5592.
- Fix the small stuff early. Lubricating hinges, clearing debris from the track, and replacing a worn safety edge before it fails keeps a small repair from becoming a motor or board replacement.
- Keep the gate, change the motor. If your gate structure is solid, you only pay for the operator, controls, and labor – not a new gate. That’s the majority of the residential work we do. Our home page walks through everything we handle.
- Match the operator to your traffic. A residential swing operator for a home entry stays cheaper and lasts longer than an oversized commercial unit that never gets used to its rating.
- Protect against the salt and the storms. Marine-grade hardware and sealed control boxes cost a little more up front and save you repair calls later, especially on beachside and waterfront properties.
If your gate is misbehaving, a fifteen-minute diagnostic often beats a weekend of guessing. Call (866) 665-5592 and we’ll get you a number you can plan around.
FAQs – Gate Motor & Opener Cost
How much does a gate motor or opener cost in Hollywood?
A replacement opener on a residential swing gate typically runs $700 to $1,200, a slide gate $800 to $1,400, and a high-cycle commercial operator $1,200 to $1,900. A full new automated gate system with controls and safety edges lands between $1,400 and $3,200. Call (866) 665-5592 for an exact quote – estimates are free.
Is it cheaper to repair or replace a gate motor?
Repair is usually cheaper if the operator is under about 12 years old and the parts are available, and repair on those systems typically runs $180 to $650 versus a $700-plus replacement. Once repair cost crosses roughly 60% of a replacement, or the parts are discontinued, replacement wins on value. We tell you which side of that line you’re on before any work starts.
What does electric gate repair cost in Hollywood?
Electric gate repair – covering control boards, loop detectors, safety edges, and access control – typically runs $180 to $650 depending on the component. A simple photo-eye replacement sits at the low end near $180 to $320, while a board replacement on a commercial DoorKing or FAAC operator can approach $480. Call (866) 665-5592 for a free estimate.
Can you come today to look at my gate motor?
We can often get an estimate scheduled quickly, but we don’t promise same-day or emergency availability until we’ve confirmed it with you by phone. Call (866) 665-5592 and we’ll give you the soonest available window for your Hollywood property.
Do you work on the brand I already have?
Yes. We service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule operators, spanning residential to high-cycle commercial. We work on the gate you have rather than pushing a specific dealer brand, so the quote reflects your system. Call (866) 665-5592 to confirm your model.
Does a Hollywood permit affect the price of a new gate opener?
Permit requirements for automated gate and access-control work vary, and on some installs a permit does add to the cost. We’ll walk you through what applies to your property when we estimate, rather than quoting a number that changes later. Free estimates at (866) 665-5592.
Your Gate Back on Track – Without Replacing What Doesn’t Need Replacing
Whether you’re dealing with a stubborn swing operator in Hollywood Lakes, a slide gate that won’t close on the beachside, or a commercial system in downtown that needs a control board, we start with a diagnosis and a straight answer on cost. No forced replacement, no dealer-brand pressure. Just gate specialists who work on the brand you have, from the control board to the hinge.
Call (866) 665-5592 for a free estimate on gate motor and opener repair or installation in Hollywood.
Pricing reflects the Hollywood market as of 2026. Carter Gate Repair offers free estimates – call (866) 665-5592.
What Our Customers Say
"Solar panel on our remote gate wasn't keeping the battery up through the winter. He repositioned it, replaced the battery, and explained the math on why the old placement was never going to work."
— Javier Delgado"The loop detector under the driveway had failed and residents were stuck holding the button. He traced it, found the break, and had the exit loop reading cars again the same visit."
— Claudia Guzman"Hinge post had rotted at the base and the whole swing gate was sagging into the concrete. He rebuilt the post rather than talking us into a whole new gate, which two other companies had pushed for."
— Destiny Whitfield