Wood & steel frame
Wrought iron
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Access Control Cost in Hollywood?
Gate access control in Hollywood typically costs between $850 and $4,500, with most residential systems landing near the $1,400 to $2,600 mark. A basic keypad-and-remote setup for a single-family driveway gate runs around $850 to $1,300 installed, while a multi-unit commercial system with loop detectors, intercom and phone-app integration can reach $3,500 to $8,000 or more. The price depends on how many entry points you’re protecting, the operator you already have, and whether the gate is wired or solar-powered.
We’re gate specialists, not generalists. Every job we do is a gate – so we’ve seen how access control behaves on the nine brands we work with daily: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. That matters when you’re pricing a job, because the operator behind the gate usually decides whether an access panel upgrades cleanly or needs a control-board change.
Key takeaways
- Typical Hollywood residential access control: $1,400 to $2,600 installed.
- Basic keypad and remote upgrade on an existing gate: $850 to $1,300.
- Commercial multi-tenant systems: $3,500 to $8,000+.
- Most of the cost is labor and components around the gate, not the gate itself.
- Free estimates – call (866) 665-5592.
Gate Access Control Cost Breakdown (2026)
Here’s how the components break down for the Hollywood market heading into 2026. These ranges reflect residential and light-commercial work on existing operators, which is most of what we quote.
| Item | Typical Cost Range |
|---|---|
| Basic keypad + remote receiver (existing gate) | $350 – $650 |
| Standalone keypad entry system (no phone app) | $450 – $900 |
| Full access control panel with keypad, remotes, wiring | $850 – $1,600 |
| Phone-app / smart access module | $600 – $1,400 |
| Intercom + gate release (audio or video) | $700 – $2,200 |
| Loop detector (in-ground vehicle sensor) | $500 – $950 per loop |
| Safety edge / photo-eyes / reversing sensors | $300 – $800 |
| Control board replacement (brand-dependent) | $450 – $1,100 |
| Low-voltage wiring runs (per linear foot, trench included) | $8 – $22 / ft |
| Full residential system installed | $1,400 – $2,600 |
| Full commercial multi-entry system installed | $3,500 – $8,000+ |
What pushes a Hollywood job up or down is usually one of three things: whether wiring already exists, how many gates or entry points you’re tying together, and whether the existing operator (say a DoorKing commercial unit or a Mighty Mule residential opener) plays nicely with a new access panel. A gate that already has a working operator and control box is the cheapest job. A gate with an aging board and no sensor wiring is where the price climbs.
The gate hardware itself – hinges, latches, the gate leaf – is usually a separate line item, and if you’re also sorting out a sagging or sticking gate, that’s worth reading on our gate repair services page before adding access control to a gate that isn’t swinging smoothly.
What Affects Gate Access Control Pricing in Hollywood
Hollywood isn’t Fort Lauderdale or Miami Beach, and the jobs here reflect that. A lot of properties sit on the inland side of the Intracoastal, where lots are wide, driveways are long, and wiring runs stretch further than they would on a tight beachside parcel. That distance is labor. Here’s what actually moves the number.
- Number of entry points. A single driveway gate is one system. A duplex, a small HOA, or a property with a separate pedestrian gate is two to four systems – and the panel, wiring, and labor multiply accordingly. A three-entry commercial job easily passes $6,000.
- Existing operator brand and age. A newer LiftMaster or Linear operator usually accepts a modern access panel with minimal fuss. An older FAAC or BFT unit may need a control-board change or adapter before the new keypad will talk to it. That’s where a specialist saves you money – we work on the gate you have, so we’re not steering you toward the brand that pays us the most.
- Wiring distance and trenching. Long driveway runs over 100 feet are common on Hollywood’s wider inland lots, and trenching through turf, shell, or paver driveways adds cost. Solar-powered gates (a lot of Ghost Controls and Mighty Mule residential installs) skip the trench, which can save several hundred dollars.
- Sensor and safety requirements. Loops, photo-eyes, and safety edges are non-negotiable on any automated gate that moves under its own power. Commercial sites with high cycle counts need heavier-duty components, and that’s a real line item.
- Salt air and storm-driven moisture. Hollywood properties close to the Intracoastal and the beach corridors deal with salt-laden air that eats at low-voltage connections and keypad housings. We spec outdoor-rated, sealed components on those properties, which costs a bit more up front and lasts considerably longer.
- Commercial vs. residential duty cycle. A residential gate opens maybe 10 to 20 times a day. A commercial gate at a Hollywood condo or marina entrance can cycle hundreds of times. That’s the difference between a $1,400 residential panel and a $5,000+ commercial system – not just more features, but heavier hardware built to survive.
If you want to understand the components more deeply before you call, our Gate Access Control in Hollywood page walks through the system types we work with.
How to Save on Gate Access Control
You don’t need to replace a working gate to modernize your access control. That’s the biggest single saving – and it’s the one most homeowners miss because they assume a new keypad means a new gate.
- Keep the gate, upgrade the panel. Our whole model is brand-agnostic. If your gate leaf, hinges, and operator are sound, we can often add modern access control for $850 to $1,400 without touching the gate itself.
- Skip the trench with solar where it fits. On a long residential driveway with no existing power run, a solar-powered operator and access system can undercut a trenched wired install by several hundred dollars.
- Bundle repair and access control. If the gate also needs a hinge replaced or a sensor re-run, doing it in one visit cuts the labor overlap. Call (866) 665-5592 and describe everything that’s off – we’ll price it together.
- Choose a system sized to your traffic. A residential driveway doesn’t need a commercial-grade multi-tenant panel. Matching the system to how often the gate actually cycles is the easiest way to avoid overpaying.
- Get a free estimate first. Estimates are free, and we’ll tell you plainly whether a repair, an access panel upgrade, or a full replacement makes more sense for your gate.
We’ve worked on every operator brand in our lineup, from a $400 Mighty Mule opener to a high-cycle DoorKing commercial system, which means we’ve already seen the failure modes on your model before we pull up. From the control board to the hinge – we diagnose the whole system, not just the part we want to sell.
FAQs – Gate Access Control Cost
Is it cheaper to repair or replace gate access control in Hollywood?
Repair is almost always cheaper in Hollywood – a fresh keypad, receiver, or control board typically runs $350 to $1,100 versus $1,400 to $2,600 for a full residential system. Unless the panel is completely dead and the wiring is shot, we can usually revive what you have. Call (866) 665-5592 for an exact quote – estimates are free.
How much does a keypad entry system cost in Hollywood?
A standalone keypad entry system in Hollywood runs about $450 to $900 installed, and a full access panel with remotes and wiring lands at $850 to $1,600. If your gate already has a powered operator and a control box, the job prices closer to the low end. Call (866) 665-5592 for a free on-site estimate.
Can you come today to look at my gate access control?
We aim to get out quickly and can often schedule visits within a short window, though same-day availability depends on the day’s route and your location in Hollywood. Call (866) 665-5592 and we’ll tell you the soonest we can be there and give you a realistic range before we arrive.
How much does commercial gate access control cost in Hollywood?
Commercial gate access control in Hollywood typically runs $3,500 to $8,000 or more installed, driven by the number of entry points, loop detectors, intercom, and high-cycle hardware. A single-entry commercial panel with loop and keypad usually lands near $3,500 to $5,000. Call (866) 665-5592 with your property details for a precise quote.
Do I need a new gate to add access control?
No – in most cases you don’t need a new gate. If your gate and operator are sound, we can add a modern keypad, remotes, or phone-app access for $850 to $1,600 without replacing the gate. We work on the gate you have, brand-agnostic. Call (866) 665-5592 and we’ll confirm what your existing operator can support.
Get a Straight Answer and a Fair Price
Access control pricing in Hollywood is knowable, and you deserve a number before anyone starts working. We quote the job you actually need – a keypad swap, a full panel, a commercial system – and we won’t push a replacement when a repair gets your gate back on track without replacing what doesn’t need replacing. Call Carter Gate Repair at (866) 665-5592 for a free estimate.
Written by the team at Carter Gate Repair, serving Hollywood and South Florida with nine gate-system brands and one specialty: gates.
Pricing reflects the Hollywood market as of 2026. Carter Gate Repair offers free estimates – call (866) 665-5592.
What Our Customers Say
"Our slide gate had been dragging for months and getting worse. Turned out the chain was stretched and one of the guide rollers had seized. Both replaced, and he adjusted the limits so it stops properly at both ends now."
— Tracy Lawson"We had a hydraulic arm leaking fluid onto the driveway. Replaced, cleaned up the stain as best he could, and it's been dry for months."
— Erin Schaefer"Fixed the immediate problem. He was honest that the operator is near end of life and I should budget for a replacement, which I appreciate even if it wasn't what I wanted to hear."
— Jodi Fletcher